Programming Wireless Keypad

Programming Wireless Keypad:

Programming New Master Password

  • Enter the Master Password “11111”.
  • Enter “8” If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).
  • Enter the Master Password (up to 5 digits), if less than 5 digits, “#” is required.
  • Enter “8”
  • Enter the Master Password again to verify.
  • Press “8” If correct, 2 short beeps - New Master Password is set (If 1 long beep is heard, start over with step 1).

Programming Master Password Back to Factory Default: (11111)

  • Enter “11111”.
  • Press “8” (long beep).
  • Enter PUK code. (PUK must be 5 digits).
  • Press “8”.
  • Enter PUK code to confirm.
  • Press “8” (2 beeps) Master password reset complete.

Programming the Keypad for Operation

  • Create Access Code: (Code you use to operate the gate)
  • Enter the Master Password “11111”.
  • Enter “9” If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).
  • Enter the new Access Code (up to 5 digits), if less than 5 digits, “#” is required.
  • Enter “9”
  • Enter the new Access Code again to verify.
  • Enter “1” or “2” representing the relay (relay 1 or 2 in the receiver) you want to control.
  • If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).
  • Now carry keypad to receiver and go to “creating communication with relay 1” below to complete programming.

Learning Access Codes in Receiver:

Create Communication with Receiver Relay 1: (Security Code/Dip Switches)

  • Carry keypad to receiver location for programming.
  • Enter the Access Code for relay 1 on the keypad and continue to press the last key entered
  • (red light blinks).
  • Press P1 (learn button) on the receiver until LD (green light) comes on and relay clicks.

Create Communication with Receiver Relay 2: (Security Code/Dip Switches)

  • Carry keypad to receiver location for programming.
  • Enter the Access Code for relay 2 on the keypad and continue to press the last key entered (red light blinks).
  • Press P2 (learn button) on the receiver until LD (green light) comes on and relay clicks.

Deleting Single Access Code:

  • Enter the Master Password.
  • Press the “7” key. If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).
  • Enter the Access Code to be deleted.
  • Press the “7” key.
  • Reenter the Access Code to be deleted.
  • Press the “7” key. If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).

Deleting All Access Codes:

  • Enter the Master Password.
  • Press the “7” key. If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).
  • Reenter the Master Password.
  • Press the “7” key.
  • Reenter the Master Password.
  • Press the “7” key. If correct, 2 short beeps (if 1 long beep is heard, start over with step 1).

-Instructions Provided By USAutomatic-