4-Button Transmitter with Visor Clip for Garage and Gate Openers - USAutomatic 030212

Details

4-Button Transmitter with Visor Clip for Garage and Gate Openers - USAutomatic 030212

USAutomatic 030212 LCR 4-Button Transmitter

• Operating Frequency: 433 MHz
• 2 year limited warranty
• Operates gates or garages
• Typically operates up to 300 feet

Transmitter Setup:

• (It is recommended that the dipswitch code be changed from the default factory setting)
• 1. Open the battery compartment door and locate the dipswitches.
• 2. Change the dipswitches to the settings you prefer, record for future reference
• Transmitter Left Button to Receiver Programming: (standard Open/Stop/Close function)
• Press and hold the left transmitter button down. Red light on transmitter should be on.
• On the receiver, push the P1 push-button until the green LD light comes on.
• Release both buttons. Transmitter left button to receiver programming is complete.

Transmitter Right Button to Receiver Programming:

• (Hold-Gate-Open) (Only if auto close timer is enabled)
• The 2-channel receiver allows for programming the P2 relay from momentary mode (default) to latching mode. Transmitter right button can be programmed to hold gate open, over-riding the auto-close feature if activated.
• Press and hold the right transmitter button down.
• Red light on transmitter should be on.
• Press the P2 push-button until the green LD light comes on.
• Release both buttons. Transmitter right button to receiver programming is complete.

Receiver Programming: Relay P2 programming from momentary to latching mode (to hold gate open)

• Press the P2 push-button until the green LD light comes on, then release. Green LD light should be steady.
• While the green LD light is on, push the P1 push-button down and release. Green LD light should be flashing. Latching mode is set.

Verifying Receiver P2 relay is programmed to latching mode:

• Press the P2 push-button until the green LD light comes on, then release.
• Green LD light should be flashing. If green LD light is steady, redo the Receiver Programming section above.

Resetting receiver P2 relay to momentary mode:

• Press the P2 push-button until the green LD light comes on, then release.
• Green LD light should be flashing.
• While the LD light is flashing, push the P1 push-button down and release.
• Green LD light should be steady. Momentary mode is set.

Erasing Single Transmitter from Receiver Memory:

• The dipswitch settings of the transmitter to be deleted must be known. If known follow the steps below.
• Set the dipswitches in a transmitter to match the switch settings of the transmitter code to delete.
• Press and hold the left transmitter button.
• On the receiver, push the P1 push-button until the green LD light comes on. Then release both.
• Press and hold the right transmitter button.
• On the receiver, push the P2 push-button until the green LD light comes on. Then release both.
• Transmitter is now erased from receiver memory.

Erasing all Transmitters from Receiver Memory:

• Press the P2 button on the receiver until the green LD light comes on. Then release P2 button.
• While LD light is on press the P1 and P2 buttons simultaneously and hold until the green LD light begins to blink slowly. It should blink 4 times then all transmitter codes are erased.